Mineralized Ground Battle: Minelab Equinox 600 vs AKA Intronik STF

Discussion in 'Intronik STF' started by SuchMuch, Mar 24, 2018.

  1. SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,025
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
  2. Igor

    Igor AKA Consultant AKA Intronika

    Messages:
    69
    Gender:
    Male
    Local Time:
    4:16 AM
    This video is made in Russia and in Russian.To assume what is going on there by a few words.The tester compared 2 detectors with multi frequency mode switched on in both.Bronze coins of different sizes,a thin gold ring and a small old silver coin were the targets.
    it was very highly mineralized soil and the tester showed how particles of ground were attreacted to a magnet.All targets were checked on the ground surface first,then under Hot Rock of approximately 10 by 10 cm.by size also attracted to a magnet.
    All the low tones were singnals of the both detectors to the soil,to the Hot Rock and to a nail.All high tones if taken place were signals to non-ferrous targets participated in the tests.
    No any additional settings in Intronik were done and some changing in Iron Bias were made in Equinox.
     
    SuchMuch likes this.
  3. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,025
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    Now these detectors are tested in real conditions:
    Equinox, Intronik.jpg
    Equinox, Intronik +.jpg
     
    miguel vicente likes this.
  4. Tragac

    Tragac AKA Veteran

    Messages:
    721
    Gender:
    Male
    Local Time:
    3:16 AM
    First Name:
    Tragac
    is it possible to do same tests with Ink and V3i
     
  5. matteotgv

    matteotgv AKA Novice

    Messages:
    17
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Daniel
    Signum:
    MFD (2.06)
    Equinox is a toy compared to any professional detector. I have an Equinox 800 (among quite a bunch of other detectors). It is not a bad machine but, also, it is not an excellent or very good machine, in no way. I've recently witnessed a demonstration of the Intronik (Victor showed it to me in Bulgaria) and I can state that comparing the Equinox with the Intronik is like comparing a Renault to a Ferrari. Just like from different worlds :)
     
    SuchMuch likes this.
  6. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,025
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    Have you seen the latest INK model or the old one?
     
  7. matteotgv

    matteotgv AKA Novice

    Messages:
    17
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Daniel
    Signum:
    MFD (2.06)
    I suppose it was the newer one, I made the attached photo. They were having two units. One of them had a new model of straight shaft, very-very comfortable and with a nice to touch silky rubber grip (not the one in the photo). I handled both, the new shaft wins hands down. It did not cross my mind to take a photo of it and now I'm sorry for that. Eh, next time :)
    intronik bulgaria.jpg
    --- Double Post Merged, May 29, 2019, Original Post Date: May 29, 2019 ---
    This is the unit of Stefan from Mikron, the AKA assembler for Europe. The one of Victor had that new shaft and it also had a small two zone sticker (red and transparent) on the upper region of the interface. I remember I have seen that sticker on other units in Youtube videos (or, maybe, it was the same unit?).

    What I liked so much was that the electronic unit was capable of sliding out from the grip of the new shaft, that means the detector becomes easier/smaller to carry in a backpack.

    Also, the unit of Victor was having an U shaped cable behind the electronic unit that was not present on Stefan's unit.

    Both units were having the same interface color.

    Hope this helps.
     
    SuchMuch likes this.
  8. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,025
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    One with new rubber handle is the latest model
     
  9. matteotgv

    matteotgv AKA Novice

    Messages:
    17
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Daniel
    Signum:
    MFD (2.06)
    Can't wait to see it available to purchase :)
     
  10. pasadete

    pasadete AKA Veteran

    Messages:
    609
    Gender:
    Male
    Local Time:
    3:16 AM
    First Name:
    Rosendo
    Signum:
    MFD (2.06)
    you arrive just in time, there are already many comrades in the forum who have lost faith in the INK, you have been like drinking 4 Red Bull all at once. :Yes::Biggrin:

    The idea is that INK enters the European market in 2020, I really do not hurry if the wait is worth it.

    The only thing that worries me a little is the frequency range of the coils, I do not use high frequencies, a coil of 7hz + 3khz would be ideal for war relics.
     
  11. matteotgv

    matteotgv AKA Novice

    Messages:
    17
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Daniel
    Signum:
    MFD (2.06)
    Please let me know what does the INK acronym mean? :)
     
  12. TS
    TS
    SuchMuch

    SuchMuch Administrator Staff Member

    Messages:
    6,025
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Rodion
    Sorex:
    Pro (1.00) Ultra
    INtroniK
     
    pasadete likes this.
  13. matteotgv

    matteotgv AKA Novice

    Messages:
    17
    Gender:
    Male
    Local Time:
    4:16 AM
    First Name:
    Daniel
    Signum:
    MFD (2.06)
    Ah, piece of cake :) Roger that, Sir, and thank you! ;)
     
  14. vint1

    vint1 AKA Master Supporter

    Messages:
    1,381
    Gender:
    Male
    Local Time:
    2:16 AM
    First Name:
    Vinny
    Sorex:
    Pro (1.00)
    Welcome mate .